![]() ![]() Turn the 2×4 back over and the following marks on the board, starting from the butt end and going up toward the headstock:Ī) 1.5” (this will be our through-body string feed)Ġ6. Use a 5/8” drill bit to drill the tuner holes.Ġ5. I went in about 5/8” in on each side and spaced the tuners roughly an inch apart. Drill tuner holes: Mark your tuner holes on the underside of the headstock. Optional: I smoothed out the underside of the headstock on my belt sander. (Still unsure? Here’s a link to a quick tutorial.)Ġ3. ![]() You can also do the same thing by running the saw in multiple passes over the shaded area and then using a chisel to remove any extra wood chips. Cut away the bottom portion in the headstock area (shaded are in the picture). Mark a horizontal line 5/8” from the top (as pictured). Cut out the headstock: Turn the 2×4 on its side and mark a vertical line 4” from the left end. Cut a standard pine 2×4 into a 32” length.Ġ2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |